No matter what construction or home improvement you are planning it is important to make sure you have the right bolts and screw heads for the job. Knowing the difference between them can ensure that whatever you are building will remain secure for many years to come. Here is a short list of some of the different types of bolts and screw heads that can be used for a variety of different products.
1. Flat Head – These are one of the most commonly used bolt and screw heads. They can be used with dimensions between 80-82 degrees and on finished surfaces to provide a secure unit of fastening.
2. Pan Head – These are the best bolts and screws to use for the replacement of binding heads that are round. It will allow you to create a low but large head of the diameter but with an outer edge that is high.
3. Round Head – The round head screw is not typically used for new building designs but used to be used quite frequently in other construction projects.
4. Fillister Head – The oval head is a bit different than this one as it is a little bit bigger and provides a much deeper slot for a tighter fit. It has the ability to increase the amount of pressure that keep a small area tightly connected. It also has the ability to be used on a counter-bored hole.
5. Flat and Oval Heads (Undercut) – This is a countersunk screw that is smaller on one-third portion of the screw it is best used on projects that require relatively short lengths. You would use a flat head 100 degree countersunk for softer materials that do not require a lot of pressure to get through.
6. Hexagon Head – You would use a trimmed hexagon head for anything that required a clean or sharp corner and items that are trimmed to relatively close levels. Or you can utilize an acorn head with a full undercut to keep up with neater appearances.
If all of this sounds relatively foreign to you, you might want to find a dealer who sells bolts in NY either online or in-store. There are places online where you can receive quotes on how much it is going to cost for whatever project you are working on. If you are not sure of which type of bolt or screw head to use then talk to an expert.
EK Fastener, Inc. if your complete source of industrial fasteners and bolts in NY. Visit their website to get a quote right away.
